Please note: this design was formerly known as Pike.
Construction - Glue-lap-plywood flat bottom.
Alternative construction - Traditional plank.
No Lofting required.
Plans include 3 sheets with instructions.
Sail Area - Sprit 60 sq. ft.
Construction - Glued lapstrake plywood.
Alternative construction - Traditional, cold-molded and strip plank.
No Lofting required.
Plans include 8 sheets.
Sail Area - Lug 87 sq. ft.
Sloop 104 sq. ft.
Yawl 121 sq. ft.
A V-bottomed plywood skiff designed for rough water - a good fishing boat. Construction: Plywood planking over sawn frames. No lofting required. Plans include 5 sheets.
A low-power, moderate-speed inboard runabout for protected waters. Designed for sawn frames and batten-seam planking.Construction: Battened-seam planking over sawn frames. Lofting required. Plans include 5 sheets.Please note: the Westerbeke 26G engine spec’d in the plans is no longer manufactured
A shoal-draft, two-sail bateau from the Chesapeake - comfortable cruising for a couple and a daysailing party.
Construction: Traditional Chesapeake bateau construction.
Lofting is required.
Plans include 7 sheets.
A small daysailer/cruiser with berths for two. Construction: Plywood planking over sawn frames. Lofting is required. Plans include 8 sheets.
A deep-V bottomed, open runabout built of plywood over sawn frames.
Construction: Plywood planking over sawn frames
Lofting is required.
Plans include 5 sheets.
Lively, fast, planing racer/daysailer. Construction: Double-diagonal planking over steamed frames. Alternative construction: Cold-molded. Lofting is required. Plans include 4 sheets.
Centerboard sloop with inside ballast and two settee berths for coastal cruising.
Construction: Carvel planked over sawn frames.
Alternative construction: Strip.
Lofting is required.
Plans include 5 sheets.
Elegant, lightweight, sailing/rowing skiff. Construction: glued lapstrake plywood. Alternative construction: carvel, strip. No lofting is required. Plans include 6 sheets and instruction booklet.