Motorboats - Outboard

Capriccio 21

Designer
Enrico Macera and Matteo Costa

In designing Capriccio we have been inspired by the aesthetics of the classic sport runabouts of the Thirties, which had the pilot seat in the extreme aft-wards of the boat and a powerful engine under a long deck in front of them.

Sportfish 570

Designer
Paolo Lodigiani and Matteo Costa

The design of Sportfish 570 comes from a collaboration with a Senegalese society, with the aim of creating fishing vessels for inland waters of modern conception.

Rustica 570

Designer
Paolo Lodigiani and Matteo Costa

Rustica 570 is a cabin motor boat ideal for coastal cruising and camping. It’s particularly suitable for river tourism in protected waters. The shallow V hull, semi-displacement, is designed for an outboard motor hosted inside the cockpit with a power range between 10 HP and 15 HP.

Silver 333

Designer
Paolo Lodigiani and Matteo Costa

The SILVER 333 is a very small classical runabout for one or two people which may easily be transported on top of a mid-size car roof. Maximum suggested power of the motor is 15/20 HP, which is sufficient for planing.

MIA 15

Designer
Andrew Walters

Mia was the second design that I published, a 12′ runabout, inspired in part by William Jackson's 1955 design for the “Ace” which was produced by the Sande Boat Works between 1956 and 1962 (www.sandeace.com), and in part by the 1950’s designs of Hal Kelly.Mia

Virginia Park

Designer
Reff Reinhart

Virginia Park is an elegant lapstrake launch. Featured in WoodenBoat #234, Sept. – Oct. 2013, Virginia Park is built in the glued lapstrake method with steam bent frames.

Volare Utility

Designer
Andrew Walters

‘Volare’ comes in two versions. This is the utility version, the console version is available as a separate set of plans. They’re both 15′4″ long and 5′ wide.Her length is that of two sheets of 8′ plywood and she’s built in two halves (bow end and stern end).

Kastri

Designer
Andrew Walters

In the spring of 2013, I started to write a book called, How to Design a Boat using SketchUp 3D Software. The subject matter was my design, ‘Kalostyn’.

Kalostyn

Designer
Andrew Walters

Kalostyn was designed as the subject matter of a book that I had planned to write called, How to design a boat using SketchUp 3D software.I created a design that had lots of curves in order to demonstrate how to put these curved forms into a 3D model, and then create and export the the f

Zipper

Designer
Andrew Walters

Zipper is an 11 foot runabout based on designs of the 1950’s for Class ‘B’ stock utility racing boats by Hal Kelly and William Jackson.This design differs from those of the period in that it is to be constructed in the 'Instant Boat' method using glass fiber and polyester or epoxy resins to make