Oar / Paddle

9' 6" Nutshell Sailing Kit

Designer
Joel White

Our pre-cut kits are cut by computer-guided routers to provide you with accurate parts. And, the kits come with just about everything needed except the elbow grease.The ladder frame—the “foundation” of the boat—is now included with the kit.

9' 6" Nutshell Rowing Kit

Designer
Joel White

Our pre-cut kits have been cut by computer-guided routers to provide you with extremely accurate parts. And, the kits come with just about everything needed except the elbow grease.The ladder frame—the “foundation” of the boat—is included with the kit.

7' 7" Nutshell Rowing Kit

Designer
Joel White

Our pre-cut kits are cut by computer-guided routers to provide you with extremely accurate parts. And, the kits come with just about everything needed except the elbow grease.The ladder frame—the “foundation” of the boat—is included with the kit.

Shellback Rowing Kit

Designer
Joel White

Our pre-cut kits are cut by computer-guided routers to provide you with extremely accurate parts. And, the kits come with just about everything needed except the elbow grease. The ladder frame—the “foundation” of the boat—is now included with the kit.

7' 7" Nutshell Pram

Designer
Joel White

Glued-lap plywood rowing or sailing tender with plenty of capacity.

Construction: Glued lapstrake plywood.

No lofting required.

Plans include 8 sheets.

13' 7" MACGREGOR Canoe

Designer
Iain Oughtred

Beamier, but no less elegant than the Wee Rob, this more stable double-paddle canoe can carry sail better.Any of the three lengths (13′ 6″, 15′ 8″, or 17′ 3″) can be built using the same plans.You’ll notice the different stem patterns on plans page 5...

12' WEE ROB Canoe

Designer
Iain Oughtred

Light, elegant double-paddle canoe for glued-seam lapstrake construction.Can be built 12′, 13′ 7″, or 15′ 2″ from the same set of plans.Construction: Glued lapstrake plywood.Alternative construction: Traditional lapstrake, cold-molded or strip.No lofting required.Plans include 5 sheets.

18' Single Shell FIREFLY

Designer
Ken Bassett

An entry-level sliding-seat pulling boat. Provides rewarding speed in an easily built hull with enough stability to keep a beginner out of trouble. Construction: Plywood. No lofting is required. Plans include 5 sheets.

Strip Kayak SKIMALONG II

Designer
Paul Ford

A stable (28 1/2″ beam) strip-built touring kayak.

Planked up with 1/4″ cedar strips.

Construction: Strip planked.

Lofting is required.

Plans include 4 sheets.

Sea Kayak SEGUIN

Designer
Rob Bryan

Fast and slim, Seguin’s 21 1/2″ beam will challenge and reward experienced paddlers.Built of 4mm plywood, this hard-chined, stitch-and-glue sea kayak includes a retractable skeg that will provide balance and control.Construction: Stitch-and-glue plywood.No lofting is required.Plans include 5 shee