If you’re in the market for a boat to build, this directory of Boat Plans & Kits is a fine place to start. And if your company sells plans or kits, we invite you to list your offerings here.
There is no charge for listing, but the FEATURED BOATS MUST BE BUILT OF WOOD.
To refine your search of this directory, use quotation marks. If you search Nutshell Pram Kit, you’ll receive all the listings that include the words Nutshell, Pram, and Kit. To refine your search, enter “Nutshell Pram Kit”; you’ll then see only the results for Nutshell Pram kits.
To refine your search, add quote marks. If you search Nutshell Pram Kit, you will get all the listings which include Nutshell, Pram, and Kit. To refine, search “Nutshell Pram Kit” and you’ll see just Nutshell Pram Kit results.
Good speed and sea keeping ability with low impact & noise. 50hp outboard or inboard diesel.
Roberts SPRAY 22 trailerable cruising sailboat you can build in wood epoxy using the plans and full size frame patterns.
The idea behind this design was to see how much boat can be squeezed out of a single sheet of plywood 4x8′ (1220 x 2440mm). The resulting boat is suitable for kids to paddle on ponds or very small lakes.
The Freedom series has gained back the turning ability found in traditional canoe shapes, without sacrificing the speed of the modern hull
Design Specs:
Flat Bottom
Open Boat
LOA. 17′-3″ (5.2m)
Beam 6′ (1.8m)
Weight 450 lbs (204 kg)
Material Plywood, Hard Wood
Fiberglass, Other.
Recommended hp. 25
“Trixie” began as an idea for a small and simple to build plywood tender, able to get out to a mooring with two or three on board, that was very light, incorporated wheels to enable transport to the slipway, was designed to provide the maximum space from two sheets of 1/4″ plywood, and could be p
The CS-18 is an open interior design with the home builder in mind. It is designed for an above deck fuel tank and less aggressive flare in the bow. These features make this design an easier and faster build and at 18.5′, it will fit in most home garages.
Shorter but more burdensome than our popular 12′ Acorn, this little gem will be slower but more versitile.Her glued-lapstrake hull can be planked up from unscarfed 8″ plywood sheets.Construction: Glued lapstrake plywood.Alternative construction: Traditional lapstrake.No lofting required.Plans inc
“Breeze” is a 10′ (3m) double paddle canoe. Two sheets of plywood needed. Stitch and glue construction using 3″(75mm) fiberglass tape in epoxy for all seams inside and out. The deciding factors when designing the boat were mostly the same as with all my designs - seaworthiness and lightweight.
14' 4" Ben Garvey Skiff designed by Doug Hylan and built by master boatbuilder Matt Elwell at Hyl
Custom 1998 Laminated Honduras Mahogany Gentlemen's Racer. 30'.
