If you’re in the market for a boat to build, this directory of Boat Plans & Kits is a fine place to start. And if your company sells plans or kits, we invite you to list your offerings here. There is no charge for listing, but the FEATURED BOATS MUST BE BUILT OF WOOD.
To refine your search of this directory, use quotation marks. If you search Nutshell Pram Kit, you’ll receive all the listings that include the words Nutshell, Pram, and Kit. To refine your search, enter “Nutshell Pram Kit”; you’ll then see only the results for Nutshell Pram kits.
To refine your search, add quote marks. If you search Nutshell Pram Kit, you will get all the listings which include Nutshell, Pram, and Kit. To refine, search “Nutshell Pram Kit” and you’ll see just Nutshell Pram Kit results.
The Noank Pulling Boat is an 18′ x 36″ [5.5m x 91cm] sliding seat rowing boat suitable for open water travel.
The Solo Packette is designed for those searching for pack canoe that they can carry to even through the most difficult approaches.
The North Sea 29 is a centerboard boat designed for sailing in the rough North Sea. She’s a fairly heavy displacement boat that will prove a very capable ocean cruiser.
The sharply raked stem and well shaped forward sections will provide increasing buoyancy as the Endeavour punches into large waves.
This is a design for a basic hull made from one piece of closed cell foam 1m x 4m x 50mm thick.
‘Volare’ comes in two versions. This is the utility version, the console version is available as a separate set of plans. They’re both 15′4″ long and 5′ wide.Her length is that of two sheets of 8′ plywood and she’s built in two halves (bow end and stern end).
An outboard skiff with a wide bottom and moderate rocker that contribute to stability and the ability to carry weight back aft.
Construction: Cross-planked bottom, lapstrake sides
Alternative construction: Plywood or glued-lapstrake plywood
Lofting is required
V-bottomed seaworthy pocket daysailer/cruiser designed for plywood construction...
A thoroughly charming boat from the board of a highly respected designer, Eel exudes strength of character.
Construction: Strip, cold-molded, or carvel.
Alternative construction: Lapstrake.
Lofting required.
Plans include 4 sheets
This cozy pocket cruiser combines simple sheet-plywood construction with more than a touch of elegance.Her board-up draft of 1′6″ lets you explore secluded coves and is easy to haul with a trailer.Construction: Plywood planking over sawn frames.Lofting is required.Plans include 6 sheets.
Construction began December 5th, 1953 at Morse Boatbuilding in Thomaston, Maine delivered May 1st
"Learning Curve", a 24' cat ketch sharpie drawn by Karl Stambaugh.
