Plans & Kits

Fast offshore cruising catamaran

Prospector “Ranger” 15 — a pocket-sized prospector.The Prospector models built by the Chestnut Canoe Company were made in lengths from 12 to 18 ft.

These handsome, practical row boats were routinely built by Nova Scotia shipwright, Jim Smith in six days, painted and ready for the water.

Cutter designed by John Hyslop in 1876. An early combination of English and American ideas, PETREL was designed according to the wave form theory.You’ll receive 2 pages of plans historical information about the boat and step-by-step instructions for half-hull building,using the lift method.The pl

Beamier, but no less elegant than the Wee Rob, this more stable double-paddle canoe can carry sail better.Any of the three lengths (13′ 6″, 15′ 8″, or 17′ 3″) can be built using the same plans.You’ll notice the different stem patterns on plans page 5...

17′ CENTER-CONSOLE FLATS FISHERMANL.O.A.: 16′ 10″L.W.L.: 15′ 1″BEAM: 6′ 5″RAFT: 9 3/4″ Static, LadenSUGGESTED POWER—25 to 75 HPTYPE: Tropical and sub-tropical flats fisherman/guide boat, especially suited for bone fish, tarpon and permit fishing in the very shallow sand flats of the Florida Keys

LOA: 33′ 1″LBP: 32′10″LWL: 26′ 8″BEAM: 10′ 0″DRAFT: 2′ 3½″/5′ 3½″DISPLACEMENT: 9,000lbs (approx)BALLAST: 2,000lbs lead under the settees.1,000lbs additional lead for trim.SAIL AREA: 388 sq.

A 16' Classic Plywood Runabout

Elegant, high-performance, sliding-seat pulling boat designed to mitigate the speed-robbing pitching associated with some sliding-seat craft.
Construction: Lapstrake planked over steamed frames.
Alternative construction: Cold-molded, strip or glued lapstrake.

Based loosely on the Folkboat, this plywood lapstrake double-ender combines comforting rough-water ability, and good looks.

Construction: Lapstrake plywood over laminated frames.

Alternative construction: Traditional plank on frame, strip or cold-molded.