Here’s a couple photos of Daniel Wainright’s home built Sailing Sharpie, launched in June 2013. It is a Spira International 14′ Inagua design. Dan and his son built it over the winter of 2012/2013.

These sectional canoes were made of plywood and fiberglass. When it was being carried to the Torch Lake in Michigan, four parts stayed in the trunk of my car and one part in the back seat. It turned into the whole canoe in a couple of minutes before hitting the clear water of the lake.

Decked double-paddle canoe. Plywood hull with pine strip decking and mahogany trim.

I started building this Glen-L Key Largo Barrelback in 1998. Finally completed after 14 years and launched in Lake Tahoe CA!

A Classic Gulf Stream fishing boat designed to be lightweight, and to take a following sea better than it’s Dory predecessors. The hull lines were from plans*, with some modifications to the interior. A laminated tow-rail and, fold-down seating in the cockpit among them.

“Sea Shadow,” Canada’s first St. Ayles skiff, was launched on June 1st. Twelve friends from the Bay of Quinte region in eastern Ontario started the project at the beginning of January. Most of the group knew their way around a woodworking shop and a few had prior boat building experience.

Restored beetle cat type boat, new north sails, great shallow water boat, perfect for Florida waters.

Nutshell pram built as tender to friendship sloop “Ruth L”.  Launched May 30,2013 at Greenlaw Cove, Deer Isle, Maine.