Plans & Kits

Dixi Dinghy plywood 3:1 dinghy

A simple and seaworthy V-bottomed centerboard cruiser with accommodations for two.

Construction: Plywood planking over sawn frames

Lofting is required

Plans include 10 sheets.

Good speed and sea keeping ability with low impact & noise. 50hp outboard or inboard diesel.

This is a design for a basic hull made from one piece of closed cell foam 1m x 4m x 50mm thick.

High capacity yacht tender with sailing ability. Exceptional stability, suited to beginner boatbuilders

Beamier, but no less elegant than the Wee Rob, this more stable double-paddle canoe can carry sail better.Any of the three lengths (13′ 6″, 15′ 8″, or 17′ 3″) can be built using the same plans.You’ll notice the different stem patterns on plans page 5...

My first boat building Project (not counting a couple of door-skin surfboards) was a Bolger Yellow Leaf pirogue, built from drawings in Bolger’s “Small Boats”.

V-bottomed cruiser designed for plywood construction with accommodations for two and inside ballast.Construction: Plywood planking over sawn frames.Lofting is required.Plans include 11 sheets.Please note: gaff rig version’s mast measurements are taken by scaling from the plans.Notice the below de

Footloose combinines the traditional lines and salty looks of the classic flatty skiff, with the ease of building and seamless integrity of plywood construction for unclomplicated boating.

A double version of the popular Kingfisher, the best recreational shells for both rough and smooth water.

Construction: Plywood planking over bulkhead-type frames

No lofting is required

Plans include 4 sheets.